Garage Floor Coatings in Eugene, OR

Your Local Eugene Floor Coating Crew

Eugene garages work harder than most. With rain from fall through spring, the garage becomes the workshop, the gym, the bike room and the place the car drips all winter. We grind, repair and coat Eugene garage floors with polyaspartic and epoxy flake systems that handle wet tires and mud, and that are moisture-tested before we start so the coating doesn't lift off a damp slab.

• Free on-site quotes in Eugene
• Full diamond-grind prep, every slab
• Moisture-tested before we coat
• Garages, basements, shops & commercial

Most Eugene calls are about garages, and the job depends on how old the house is. In South Eugene, the Friendly Area and around Crest Drive, many garages are decades old. The slabs have oil stains, pitting and hairline cracks, and some have a peeling paint job from years ago. Those floors need a full diamond grind down to clean concrete, plus crack and spall repair, before any coating goes on. Done right, an old slab can end up looking better than the day it was poured.

In the newer builds out Santa Clara, River Road, Cal Young and the Southeast Hills, it's usually a bare builder slab that has never been coated. Those installs are quick, but we still moisture-test every slab. Valley soil stays wet for months, and a slab that looks dry can still push up vapor that will lift a coating that wasn't primed for it.

Either way, you get a full-flake polyaspartic system that doesn't lift under hot tires, wipes clean when you track in mud, and won't yellow near the open door in summer. Most Eugene garages are ground, coated and finished in one day.

• Full diamond-grind prep: no acid etch, no 'clean and roll'
• Crack, pit and spall repair on older South Eugene slabs
• Moisture testing on every slab, new construction included
• Full-flake polyaspartic systems rated for hot tires
• Home gym, bike room and workshop setups
• Lifetime warranty on residential floors